Instructions (continued)

For each screen mounting

• Bolt the "arm clamp" to the "clamp holder" using the appropriate sized bolt. Do not fully tighten the bolt yet because you will need to adjust it later when you are locking the screen into it's final position. Just tighten it enough to prevent the clamp from moving.
• Hold one of the foam pads over the hole on the front of the screen, and then place the "front plate" over it. If I remember correctly there will be a pair of small stumps on the plate to help line it up correctly with the corresponding holes in the screen.
• Now put the bolt through from the front of the screen to stop the "front plate" moving. You will need to hold this in place until you get the "back plate" fitted.
• Put the other foam pad over the protruding bolt on the back of the screen, and then place the "back plate" over it. The bolt should still protrude right through into the recess on the rear of the "back plate".
• Finally fit the "clamp holder" into the recess on the "back plate" and tighten the bolt to stop it all falling apart. Again it is not necessary to fully tighten the bolt because you will need to adjust it later.

Repeat the above process for each of the remaining screen mountings.